MHI Vestas expands manufacturing facility at Port of Esbjerg

16.05.2017
MHI Vestas Offshore Wind is constructing a PCM assembly facility at the Port of Esbjerg (Photo: MHI Vestas)
MHI Vestas Offshore Wind is constructing a PCM assembly facility at the Port of Esbjerg (Photo: MHI Vestas)

Construction of a 5,600 square meter facility at the Port of Esbjerg is underway to house manufacturing of power converter modules (PCM) exclusively for MHI Vestas Offshore Wind.

In accordance with its V164 manufacturing plan, MHI Vestas continues to ramp up production for the 8 MW offshore wind turbine. Broad demand for the platform has resulted in a ramp-up of employment in Denmark and the introduction of a dedicated assembly facility for PCM’s at the Port of Esbjerg.

The Port of Esbjerg has held a public tender for development of a purpose-built, state-of-the-art 5,600 square meter facility to accommodate PCM assembly for MHI Vestas. The hi-tech facility will create a dedicated space for PCM assembly, located close to pre-assembly, and will enable the company to further utilise the Port of Esbjerg’s expanding offshore wind expertise.
Just as MHI Vestas ramped up production staff on the Isle of Wight in the UK last fall, and in Nakskov and Lindø in the spring and summer this year, the company now is preparing for this fall ramp-up at Esbjerg.

MHI Vestas Chief Manufacturing Officer, Robert Borin, said: “Since MHI Vestas brought the game-changing V164 - 8.0 MW turbine to the offshore wind market, we have, as expected, seen extraordinary demand for the platform. The next phase of our production plan calls for a hiring ramp up for blade manufacturing in Nakskov, nacelle production in Lindø, and Power Converter Modules (PCM’s) at the Port of Esbjerg. PCM modules will be assembled in Esbjerg from Q4 2017.”

MHI Vestas / Funke

 

Similar Entries

Siemens Gamesa has secured a new order in India from Ayana Renewable Power Six Private Limited to supply a 302MW project, providing another boost to the country’s wind energy drive. A total of 84 units of the SG 3.6-145 wind turbines will be installed for the project in the Gadag district, Karnataka State.

Webinar "Operation of Wind Power Plants in Cold Climate 2021" (pict. VGB)

For the first time the results of the VGB Research Project “Comparison of blade-based ice detection systems” will be presented at the webinar
"Operation of Wind Power Plants in Cold Climate".

Using Bolt-Check to monitor clamp load (pict.: R&D A/S)

The Bolt-Check tool reduces preventative maintenance time, resulting in service cost reductions while maximizing uptime; Reduced health and safety costs.

Sometimes one and one add up to more than the mere addition of numbers. Structural Health Monitoring (SHM) of rotor blades is a complex and demanding task that requires very good hardware as well as professional data analysis in order to be able to make really precise and early statements about structural damage to the rotor blade. For this reason, two specialists have now joined forces to offer wind farm operators the best possible combination of forces on the market.